New Trigger-Point™ Lever Clamp Enables Easier Inspection While Returning Info Back to the Shop Floor Faster

Phillips Precision's new Trigger-Point™ lever clamp employs the same cantilever design as the heavy-duty lever clamps and are available in 1.5", 2.5" and 3.5" sizes.

Force is controlled with a thumb screw rather than downward pressure to reduce part marring. The narrowed tip provides more concentrated force and greater access to the work piece.

The series of clamps generate up to 30-lbs of force and the cantilever design allows for clamping force down to the fixture plate. The clamps assemble quickly and self-align. The post is steel and clamp lever is black anodized aluminum (thumb screw included).

The clamp can be ordered with a 1/4-20 or M6 threaded post. Clamps are sold individually or in a variety of sets.

Want more information? Click below.

Phillips Precision

Rate this article

[New Trigger-Point™ Lever Clamp Enables Easier Inspection While Returning Info Back to the Shop Floor Faster]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):

Comments:


Type the number:



 

Copyright © 2021 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy