ER Collet's Anti-Friction Coating Helps Improve Run-Out

Parlec has released the new P3 ER collet system, the first coated ER collet system according to the company.

Parlec P3 ER collets feature a special anti-friction coating on the 30° face of the collet that interfaces with the collet nut when tightening during tool setup. According to Parlec, the anti-friction coating reduces radial distortion helping improve run-out.

Parlec P3 ER collets have a repeatably accuracy of 0.0001" and are sealed for coolant pressures up to 2,000 PSI due to a special slotting design.

Parlec P3 ER collets are available in ER11, 16, 20, 25, 32 and 40 in inch and metric sizes and are meant to be used with on-size tooling. P3 ER collets may be used in any ER collet chuck to improve accuracy and cutting performance.

Want more information? Click below.

Parlec

Rate this article

[ER Collet's Anti-Friction Coating Helps Improve Run-Out]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):

Comments:


Type the number:



 

Copyright © 2022 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy