M.A. Ford's New High-Feed End Mill Features Rolled Cutting Face for Extra Strength and Longevity

M.A. Ford is introducing the new TuffCut® HF High-Feed, End Mill.

This multi-flute high performance mill is designed with a positive axial rake that allows this tool to perform well in a range of materials with a hardness of 52 HRC and under.

The FHFP is engineered with a rolled cutting face that provides increased strength and prolonged tool life, adding cost savings. With high metal removal roughing in 3D shapes, long reach applications into deep/tight pockets and slots, the FHFP is perfect for a broad range of industries.

This series is offered in metric sizes from 6mm diameter to 16mm and multiple neck lengths from 3xD to 8xD. Coated with an ALtima® Q coating, the FHFP has optimal heat & wear resistance for increased tool life. The central coolant design allows for excellent chip evacuation to prevent recutting of the chips along with the cutting geometry that thins the chip which provides reduced cutting forces and heat adding to the life of the tool.

Want more information? Click below.

M.A. Ford

Rate this article

[M.A. Ford's New High-Feed End Mill Features Rolled Cutting Face for Extra Strength and Longevity]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):

Comments:

Type the number:

Copyright © 2024 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy