Electronic Pump Presses Ideal for Stamping, Bending, and Forming Metal Sheets, Tubes or Rods

Palmgren's Electronic Pump H-Frame Presses could be an excellent fit for a wide range of applications -- from fabrication shops to prototype labs.

The presses are commonly used for metal fabrication processes such as stamping, bending, and forming metal sheets, tubes or rods as well as assembly operations. They are effective in assembly operations for pressing bearings, gears or components into place.

Available in a variety of shapes and sizes, they feature a pressure gauge for direct pressure readings, an easily adjustable table for quick height changes between applications, and holes in the side frames to allow for insertion of long material.

The presses electronic operation and single acting cylinder design result in increased performance and enhanced operations. The Electronic H-Frame line is sold in 10-ton, 25-ton and 50-ton models. More than 100 years old, Palmgren is a C.H. Hanson® brand.

Want more information? Click below.

Palmgren

Rate this article

[Electronic Pump Presses Ideal for Stamping, Bending, and Forming Metal Sheets, Tubes or Rods]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):

Comments:

Type the number:

Copyright © 2025 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy